1. I measure from the end of the buckle to the center hole of my belt to determine how much to shorten it.
2. I remove the cap by unscrewing it using a flat screwdriver.
3. I report the measurement to be removed.
4. I cut using a cutter or a good pair of strong scissors (optional: burn the wires with a lighter)
5. I make sure to choose the hole corresponding to the type of buckle (full buckle or buckle with loop)
6. I report the hole using the guide or according to the diagram above
7. I drill the hole ø 3 mm
8. I screw the cap back on with the buckle
